Zone Led

How do I wire my neon lights to a toggle switch?

I have four pilot neon lights from Auto Zone, and yes they have the plug on them to put in the cigarette lighter. I also purchased a blue led rocker toggle switch (30amps) and it has the prongs, (+)power, load, (-)ground. So do i need to cut those plugs off and wire the leads to the battery? Please explain on how to do this and if possible a diagram? They are going into a 2004 dodge neon
so once i wire the positive on the switch to the battery, then I wire the ground to a screw on the chassis, then do I cut the plug on the lights and twist the two ends together that came off the plug and run them all into one wire then hook it up to the load?? I have four neons

"so once i wire the positive on the switch to the battery, then I wire the ground to a screw on the chassis, then do I cut the plug on the lights and twist the two ends together that came off the plug ..."

No, twisting the wires together won't work. One wire gets connected to ground and the other needs to be connected to the 'load' spade on the switch.

Carefully take the cigarette plug apart and determine which wire goes to the tip of the plug. This is the positive wire, the wire that goes to the side of the plug is ground. If there is a fuse in the plug, you'll need to run an inline fuse between the battery and the switch with hte same sized fuse.

If there is any kind of circuitry in the plug, you will have to use it in the final circuit. You'll need a project box to contain this circuit board if it exists.

Can"t find what you are looking for? Check out these products from Amazon.